Sanyo PLV-Z3000 Instrukcja Właściciela

Multimedia ProjectorMODEL PLV-Z3000Owner’s Manual

12To ensure safe operation, please observe the following precautions: ● Use two (2) AA or LR6 type alkaline batteries. ● Always replace batteries

15Video EquipmentS-video Cable S-VIDEO OutputS-VIDEOVIDEOComposite Video OutputVideo Cable(RCA x 1) Video, S-videoUse a video cable or a S-video cable

16Connecting to a ComputerRGB ScartUse a Scart-VGA cable (optional). Video EquipmentCOMPUTERRGB Scart21-pin OutputScart-VGACable Video EquipmentHDMI

45Maintenance and CleaningFollow these steps to replace the lamp.Replacement lamp can be ordered through your dealer. When ordering a projection lamp

46Maintenance and Cleaning123This projector uses a high-pressure lamp which must be handled carefully and properly. Improperhandling may result in ac

53AppendixTechnical Specifications0.74” wide TFT Active Matrix type, 3 panelsMultimedia Projector16.1 lbs (7.3 kg)15.75” x 5.75” x 13.62” (400 mm x 14

4CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE EXCEPT LAMP REPLACEMENT. REFER SERVI

5All the safety and operating instructions should be read before the product is operated.Read all of the instructions given here and retain them for l

AC Power Cord for the United Kingdom: This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pi

Moving the ProjectorWhen moving the projector, make sure that the automatic slide shutter is closed, retract the adjustable feet, and lock the lens wi

This projector uses nominal input voltages of 100 – 120 V or 200 – 240 V AC and it automatically selects a correct input voltage. It is designed to wo

9Part Names and Functionsq COMPUTERConnect the computer output signal, or RGB Scart 21-pin video output to this connector (p.17).Rear TerminalSERVICEP

10Top Controlqwert y u ii INFO. button Display the input source information (p.43).t INPUT button Select an input source (p.24).e LAMP REPLACE in

11Remote Controlwe!5o LAMP CONTROL button Select a lamp mode (pp.23, 29).e LIGHT button Light up the remote control buttons for about 10 secon